When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Including 15 Common Modules Such As LED, Button, Buzzer, Etc.
Out Of The Box As A Whole Kit, Or Can Be Separated To Use Independently
Comes With Online Development Resources And Manual
Features At A GlanceNote: the PH2.0 cables are required for the connection with pico after the modules are separated.
Based On Raspberry Pi PicoSuitable For Raspberry Pi Pico Series Boards, Adapting 40PIN Color-Coded Header
Comes With Relevant Resources And Tutorials To Help You Get Started Quickly
Pico-Sensor-Expender① Onboard PH2.0 header for 3.7V Lithium battery, allows recharging the battery and powering the board at the same time.
② Onboard PH2.0 4PIN headers for connecting modules
Adjustable voltage output, after the output voltage exceeds the LED conduction voltage, the LED brightness will increase with voltage
Photoresistor ModuleFor detecting the ambient light brightness, the output voltage will decrease as the brightness increases
Sound Sensor ModuleFor converting the sound signal into electrical signal, which is amplified through operational amplifier and then inputted to the comparator, providing analog voltage output and digital output respectively. Adjustable output amplitude via potentiometer A and digital interface trigger voltage via potentiometer D.
RGB LED ModuleOnboard passive buzzer, outputs different sounds according to the different frequencies of the electrical signal.
IR Receiver ModuleOnboard IRM-H638T/TR2 for receiving infrared remote control signal
IR Transmitter ModuleOnboard TSAL6400 for transmitting infrared remote control signals, with the infrared light wavelength of 940nm.
Button ModuleOnboard 12×12mm button, for human-computer interaction
LED ModuleOnboard 10mm LED with soft light, for status indication
Temperature/Humidity ModuleOnboard SHTC3 chip supports measuring 0 to 100% relative humidity and -40°C to 125°C temperature, with a typical measurement accuracy of ±2% relative humidity and ±0.2°C
EEPROM ModuleOnboard AT24C04 chip for preserving 2Kbit of data when powered down
Motor Driver ModuleAll Modules Are Connected To Pico Via PCB Castellated Holes, No Soldering Or Wiring Required, Or Can Be Separated To Use Independently
Warm tips: please pay attention to the sharp cuts and fragments when disassembling the modules.For Raspberry Pi 3 Motor Stepper Motor Driver Servo Robot Expansion Board dl45
$20.05
Raspberry Pi Pico Entry-Level Sensor Kit Integrates Expansion Board & 15 Modules
$48.44
10.1 inch touchscreen for rasberry pi 1,2,3,4 Model B
$39.99
Popular Tutorials
Alarms and Indicator Circuit diagrams