pot plant water tester circuit

Home/Garden related Circuits

Click here for Electronic Circuits main page

Pot plant water tester Click here for the circuit diagram

This simple device checks if their is water in a pot plant. You stick the two probes(paperclips)into the pot plant and if the LED lights, it means there is water in the pot plant.

You need to adjust the 47k potentiometer to set the level at which the LED goes on.

Submitted by:
Betty Bone
boneb@mweb.co.za

Disclaimer: All the information present on this site are for personal use only. No commercial use is permitted without the prior permission from the authors of this website. All content on this site is provided as is and without any guarantee on any kind, implied or otherwise. We cannot be held responsible for any errors, omissions, or damages arising out of use of information available on this web site. The content in this site may contain COPYRIGHTED information and should not be reproduced in any way without prior permission from the authors.

Looking for custom Electronics Design, Prototyping & Manufacturing?