•  
  •  

Pot plant water tester

This simple device checks if their is water in a pot plant. You stick the two probes(paperclips)into the pot plant and if the LED lights, it means there is water in the pot plant.

You need to adjust the 47k potentiometer to set the level at which the LED goes on.

Submitted by:
Betty Bone
boneb@mweb.co.za

If there are any problems please contact webmaster@electronic-circuits-diagrams.com

Please share & like


US NEW High Temperature Type K Thermocouple Core Ceramic Kiln Probe 2372°F picture

US NEW High Temperature Type K Thermocouple Core Ceramic Kiln Probe 2372°F

$7.99



Digital TM-902C Thermometer Meter Single Input  K Type Thermocouple Probe USA picture

Digital TM-902C Thermometer Meter Single Input K Type Thermocouple Probe USA

$9.19



Fluke 80BK-A Type K Thermocouple, Temperature Bead Probe, Clamp - Multimeter.  picture

Fluke 80BK-A Type K Thermocouple, Temperature Bead Probe, Clamp - Multimeter.

$14.99



Screw high temperature thermocouple - k type 6 MM thread probe sensor 1M 3.3ft picture

Screw high temperature thermocouple - k type 6 MM thread probe sensor 1M 3.3ft

$7.39



Temp Thermocouple K type, stainless Steel Probe, 12 ft (3.66M), Teflon sealed picture

Temp Thermocouple K type, stainless Steel Probe, 12 ft (3.66M), Teflon sealed

$14.00



  • Why Marc

    Using a PNP would have make more sense…