•  
  •  

TV remote control Blocker

- Designed by Naveen P N

Just point this small device at the TV and the remote gets jammed . The circuit is self explanatory . 555 is wired as an astable multivibrator for a frequency of nearly 38 kHz. This is the frequency at which most of the modern TVs receive the IR beam . The transistor acts as a current source supplying roughly 25mA to the infra red LEDs. To increase the range of the circuit simply decrease the value of the 180 ohm resistor to not less than 100 ohm.

It is required to adjust the 10K potentiometer while pointing the device at your TV to block the IR rays from the remote. This can be done by trial and error until the remote no longer responds.

If there are any problems please contact webmaster@electronic-circuits-diagrams.com

Please share & like

Tektronix DTG 5078 Generator Mainframe Option 1R
$299.0 Tektronix DTG 5078 Generator Mainframe Option 1R picture
Agilent E8401A VXI Main Frame T51092
$399.0 Agilent E8401A VXI Main Frame T51092  picture
TELLABS 81.8830 - ULC-1 IPUIAVXAAB Telecommunication Mainframe Module Card Board
$2000.0 TELLABS 81.8830 - ULC-1 IPUIAVXAAB Telecommunication Mainframe Module Card Board picture
Keithley 707 6- Slot Switching Matrix Mainframe (Parts/Repair)
$149.99 Keithley 707  6- Slot Switching Matrix Mainframe (Parts/Repair)  picture
TEKTRONIX TLA 704 LOGIC ANALYZER COLOR PORTABLE MAINFRAME- TLA7M3, P6417 probes
$500.0 TEKTRONIX TLA 704 LOGIC ANALYZER COLOR PORTABLE MAINFRAME- TLA7M3, P6417 probes picture

Warning: Unknown: write failed: Disk quota exceeded (122) in Unknown on line 0

Warning: Unknown: Failed to write session data (files). Please verify that the current setting of session.save_path is correct (/tmp) in Unknown on line 0