Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best Selling in Ultrasonic Cleaners
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on Ultrasonic Cleaners
The product arrived undamaged and works well. The only reason for not giving it a five star review is the instructions that come with the unit are crap. I had to rely on a friend to get the proper instructions so that I could learn how to use the machine properly for if not more than likely I'd never been able to figure out how to use the machine. The coil winding machine is quite, smooth operating, and seems to be capable of more than I am able to program into it right now. Though I will admit in order to use it fully one must know some sort of CAD program and able to design transformer bobbins to be able to interpret some of the data fully. All in all it's a good machine for the money. Some things that are needed to improve the product are a full video of how to use every aspect of the machine especially for programing the unit to do various jobs like multispooled bobbins. Detailed measurements of the bobbin shaft and shaft's length. In the photos I made a modification so the unit can wind bifilar coils that I think the machine should come with standard. Read full review
Verified purchase: Yes | Condition: New
No Manual, Wrong plug, improper fixtures for most wire, and no bobbin holding system. Here's a kit good luck and if your not a smart engineer your screwed. Yes, I got it working, programmed, and rewired with an American plug, strain relief, and transient protection interface up to UL standards. Your big hint is no serial number/ model number / name plate. Start with Taily Automation for manuals and a road map
Verified purchase: Yes | Condition: New
The unit was well packaged and arrived with no damage. The quality of the unit is actually better than I was expecting. Everything so far seems to work. I looked inside at both the mechanical and electrical/electronic and found everything to be fine. Two areas for improvement would be instructions better than one page supplied and at least one threaded rod for the chuck or accessories that could be purchased. There is an English 23 page manual online for the controller (search for CNC-210S user manual). Overall I am very happy with the purchase and I got it when they had a sale running.
Verified purchase: Yes | Condition: New
I immediately assembled it and ran it. The temp fluctuates between 220 and 180 Celsius. Kind of a large swing, haven't dried a shirt yet. Disappointed that it doesn't hold the temp. Otherwise it's a decently built unit, just hoping it gets the job done.
Verified purchase: Yes | Condition: New
Good product and works well. But is hard to clean because you have to unbolt the head to clean it.
Verified purchase: Yes | Condition: New