Moderator: pebe
i brought that 2 components.Could we able to print the schematics from pdf file ?OR because of printing size issues i need to rebuild in kicad same pcb schematic?
What about instead of three pin 3.58MHz crystal resonator, two pin 3.58MHz resonator?
pebe wrote:Hi,
In your other thread you said you had made the ‘Elektor’ ESR meter.
Then in this thread you have bought components for the ‘EVB’ ESR, and the Z86 micro from that seller will be loaded with software for the ‘EVB’.
But you are also talking about the ‘Blue’ ESR meter.
pebe wrote:So which ESR are you talking about in the next quote?
Then i should buy Blue Esr Kit otherwise it doesn't make any sense.pebe wrote:The circuit (schematic) is already given in the link you gave for the ‘Blue’ one. Are you referring to making the PCB? If so I would advise against it. If you are going to make this meter I would strongly advise buying at least the PCB and programmed micro; if you’re a newbie it’s not competitive to make the PCB, and you probably won’t to able to buy the micro's software on its own.
The ‘Blue’ model uses a 2pin resonator, anyway.
Then i should buy Blue Esr Kit otherwise it doesn't make any sense.
savetheday wrote:Hi everyone
......
And what is (miniature pushbutton switch with cap)?Are we able to use normal switchbuttons?
Users browsing this forum: No registered users and 10 guests