Hey guys,
I am trying to build a circuit that runs with two 4.2V batteries in parallel with a 30A max draw that will use a momentary push button while also powering an LED. The top resistor on the page is interchangeable from .2 ohm to say .7 ohm, pulling 21A to 6A respectively, on a 510 connector. The push button is rated for 12-240V at a max 3A while the LED is rated for 1.7V at a max 700mA. I ran each area to an n type mosfet shown at the bottom. The issue I am running in to is that the program I am using is showing that the connection will not function as I had hoped. I am not sure if I am missing something, or if the program is just confused at what I am doing. Any help is greatly appreciated. Thanks guys!