Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best Selling in Plasma Cutters
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on Plasma Cutters
It cut my 1/4 inch steel like butter on the 120 volt i cannot wait to use it o 220 this is a nice plasma cutter. i put a regulator on mine so the pressure is always what the machine recommends they are cheap at harbor freight around 6 dollars . i also put the better ground clamp on mine. Went and bought the Cart for it about 50 dollars also bought a 25 foot 220 extension cord I can use mine anywhere in the shop now with ease.
Verified purchase: Yes | Condition: Pre-owned
I have put off buying for awhile because I have every other type of metal cutting tool you can think of, I think this will be my go two alot more due to speed and ease of use. Everything I have seen so far after a couple hours use is good quality and we'll thought out.
Verified purchase: Yes | Condition: New
This is a great plasma cutter to have on the farm or in the garage. I've cut up to 3/8" on the 240v side with ease. The specs said it will cut 5/8" material, but haven't tried it yet. I like the stand-off cutting tip better than the drag tip that I've used on another plasma cutter. It seems to cut better. I highly recommend this plasma cutter.
Verified purchase: Yes | Condition: New
This cuts as advertised. Works great on the 110 volt up to 1/4” steel, then if you cut something thicker just switch to 220 volt and raise the amps and air pressure. It will cut 3/4” steel at the highest setting.
Verified purchase: Yes | Condition: Pre-owned
Works just as good as the more expensive brands.
Verified purchase: Yes | Condition: Pre-owned