MS-FEC2611 CONTROLLER METASYS@ SYSTEM JOHNSON CONTROLS For Sale
This item has been shown 86 times.
MS-FEC2611 CONTROLLER METASYS@ SYSTEM JOHNSON CONTROLS :
The FEC26 controllers are part of the Metasys® system Field Equipment Controller (FEC) family. These controllers run pre-engineered and user-programmed applications and provide the inputs and outputs required to monitor and control a wide variety of HVAC and otherfacility equipment.
The FEC controllers operate on an RS-485 BACnet® Master-Slave/Token-Passing (MS/TP) Bus as BACnet Specific Controllers (B-ASCs) and integrate into Johnson Controls® and third-party BACnet systems.
Supply Voltage :24 VAC (nominal, 20 VAC minimum/30 VAC maximum), 50/60 Hz, power supply
Power Consumption : 14 VA maximum for FEC2611 only
Ambient Conditions : Operating: 0 to 50°C (32 to 122°F); 10 to 90% RH noncondensing
Addressing : BACnet® MS/TP: DIP switch set; valid field controller device addresses 4–127 (Device addresses 0–3 and 128–255 are reserved and not valid controller addresses.) N2: DIP switch set; valid controller device addresses 1–255
Communications Bus :
RS-485, field selectable between BACnet MS/TP and N2 communications:
3-wire FC Bus between supervisory controller and field controllers.
4-wire SA Bus between field controller, network sensors, and other sensor/actuator devices, includes a lead to source 15 VDC supply power (from field controller) to bus devices.
N2 Open Protocol:
N2/FC Bus: 1.0mm (18 AWG) standard 3-wire, twisted, shielded cable recommended between the supervisory controller and field controllers