On eBay Now...
BIGTREETECH Octopus V1.1 Control Board 32bit TMC2209 TMC2208 Stepper Driver S... For Sale
When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
BIGTREETECH Octopus V1.1 Control Board 32bit TMC2209 TMC2208 Stepper Driver S...:
$87.09
BIGTREETECH Octopus V1.1 Control Board 32bit TMC2209, TMC2208 Stepper Driver, Support DIY Klipper Firmware and Raspberry Pi Online Printing for Voron V2.4 Upgrade 3D Printer
- 【Main Control Chip】Uses a 32-bit ARM Cortex-series STM32F446ZET6 main control chip with a core frequency of 180MHz.
- 【Strong DIY Support】This motherboard supports up to 8 stepper drivers with 9 stepper driver outputs in total; And up to 6 PWM fans and 2 always-on fans with the ability to individually select the voltage rail that will drive each fan. Select from Vin, 12V or 5V.
- 【Realize Online Printing】Interfaces with a Raspberry Pi using emulated serial over USB or direct UART to any of the serial ports on the board, to realize Klipper Firmware and Raspberry Pi Online Printing.
- 【Motherboard Expansion Function】Support BLTouch, locked-rotor detection, shutdown after printing, resume printing after power failure, CAN bus, U disk function, IIC expansion; at the same time reserved WIFI interface, PT100 thermistor interface (optional, Only reserved interfaces, customers need to purchase chip welding, please pay attention.), dual Z-axis printer.
- 【Increase Protection Function】Uses high-performance MOSFETs to increase heating efficiency while also reducing heat generation on the motherboard. Supports “print from SD card” and “print via USB OTG” using the integrated USB-A port.
BIGTREETECH TMC2240 V1.0 SPI Stepper Motor Drivers Silent Stepper Driver with...
$60.11