Electronics Forum

Electronics Circuits & Projects discussion forum. Get help with electronics.


security alarm modification

Discuss all your electronics engineering related technical problems and other questions pertaining to design problems in any field of Electrical/Electronics/Computer Hardware

Moderator: pebe

security alarm modification

Postby jac » Sat May 10, 2014 9:30 pm

hi all, i'm new to this forum...

i bought a cheap alarm system that just has an IR beam emitter and reflector and analog circuit with small speaker that sounds an audible tone or alarm siren when the beam is interrupted (probably used in department stores for when someone enters, a tone is sounded). It has an output of 0.5V - 0.8V for a counter (not included) that i'd like to use in some sort of relay, whereby, i can energize a better external siren & flashing strobe light that i am buying separately. This new siren runs on 12V with a current draw of about 200mA. The alarm system can output the 12V too, and i assume the counter feed can handle the 200ma draw from this external siren/light. My questing is: do you know of a component that can input the 0.5V - 0.8V 'trigger'/counter signal (when the IR beam is interrupted) and allow the 12V to run the external siren/light for about 60s then open and return back to an 'armed state'? (similar to a car alarm scenario in terms of 60s time and reset). Currently, this counter signal only occurs when the beam is interrupted but immediately disappears when the beam is free of obstruction...so, naturally, i'd like to have the external siren/light keep running for 60s to help scare away my intruder, even if he only momentarily interrupted the beam.

Thanks in advance for any advice or assistance.

-John
jac
 
Posts: 2
Joined: Thu May 08, 2014 5:26 pm

Re: security alarm modification

Postby pebe » Wed May 14, 2014 1:34 pm

0.5V is a bit too low to trigger most things. If the minimum was 0.6v and there was some form of current limiting of the source (through a resistor?), then you could get it to trigger an NPN transistor and that in turn could trigger a 555 timer set to give the 60 sec period you want. Even then, a 555 can only source or sink 200mA so you would maybe need another NPN or FET to drive the siren.
pebe
 
Posts: 1058
Joined: Tue Dec 09, 2003 11:12 pm
Location: Ellon, Scotland

Re: security alarm modification

Postby jac » Thu May 15, 2014 4:20 pm

thanks for reply...

-john
jac
 
Posts: 2
Joined: Thu May 08, 2014 5:26 pm


Return to EE quiz questions & problems



Who is online

Users browsing this forum: No registered users and 2 guests

LMH6503 VCA Linear in voltage VGA 100MHz LMH6503MA
$1.58
LMH6503 VCA Linear in voltage VGA  100MHz  LMH6503MA pictureWINGONEER Small DC Buck Volt Converter Step Down Voltage Regulator Module Boa...
$7.6
WINGONEER Small DC Buck Volt Converter Step Down Voltage Regulator Module Boa... pictureVoltage Regulator Step-down Power Supply Module DC 4-40V To DC1.25-36V 8A 200W
$3.49
Voltage Regulator Step-down Power Supply Module DC 4-40V To DC1.25-36V 8A 200W  picture12V 24V AUX Main Digital LED Car Voltmeter Dual Display Voltage Gauge Battery
$13.49
12V 24V AUX Main Digital LED Car Voltmeter Dual Display Voltage Gauge Battery picture


cron