Electronics Forum

Electronics Circuits & Projects discussion forum. Get help with electronics.


EL Wire Dimmer Help

New to electronics? Don't know where to start. No problem! Post your questions here.

Moderator: pebe

EL Wire Dimmer Help

Postby tony48 » Fri Jun 21, 2013 5:08 am

Hello,

I am attempting to dim EL wire using a premade PWM circuit that I purchased online from Amazon here.

For those who don't know, to power EL wire an inverter must be used. This inverter takes DC input voltage and converts it to an AC signal output that excites the phosphorous in the EL wire causing it to glow. My question is should I place the PWM unit before or after the inverter (So, should I modulate the DC or AC signal?).

I attempted both of these in my circuit. Modulating the DC signal (before the inverter) resulted in dimming but only with about 5 degrees of the potentiometer's range of motion. The rest of the range of motion was either completely on or completely off. Modulating the AC signal (after the inverter, directly before the EL wire) led to no light from the EL wire.

Any help here would be greatly appreciated, Thanks very much!

-Tony G.
tony48
 
Posts: 2
Joined: Wed Jun 12, 2013 2:30 am

Return to Electronics newbies



Who is online

Users browsing this forum: No registered users and 1 guest

Olympus CV-60 Processor W/ Olympus OSF-V60 Sigmoidoscope OEM
$699.95
Olympus CV-60 Processor W/ Olympus OSF-V60 Sigmoidoscope OEM   pictureZebra ZQ520 Mainboard ( CPU Board ) for ZQ52-AUE0000-00 - P/N: P1048705-101
$205.0
Zebra ZQ520 Mainboard ( CPU Board ) for ZQ52-AUE0000-00 - P/N: P1048705-101 pictureRobot Coupe R301 Ultra Dice Food Processor
$350.0
Robot Coupe R301 Ultra Dice Food Processor pictureAvaya IP Office 500 V2 Processor 700476005 Business Phone System with Modules
$49.99
Avaya IP Office 500 V2 Processor 700476005 Business Phone System with Modules picture


cron