by GaS753 » Wed Dec 05, 2012 7:53 pm
Yes it does pebe! This is off the subject but here is how I hooked up the pulley. A hose clamp is what holds the wooden dowel pulley shaft to the motor’s metal shaft. A friend drilled a hole in the center of the one end of the dowel only a hair larger and slightly longer than the metal shaft. Then a jig saw was used to cut twice down through the center hole, cuts were perpendicular to each other. Then I placed a small hose clamp over this end of the dowel. Pressed the motor shaft into the center hole - it was a tight fit - and then tightened up the hose clamp as tight as I could. Can you offer a better way?
You have better local stores than we do, but I am still looking, but thanks for the link just in case. Those screws are tiny!
I believe I would choose to have the LEDs on during the operation as that would be the least amount of time for them to be on if I am thinking straight - am I? Thanks again for all your good help. Garry (GaS753)