Electronics Forum

Electronics Circuits & Projects discussion forum. Get help with electronics.

Skip to content

[Return to Electronics Circuits Page]

Problems with battery discharging circuit

Discuss about electronic circuits here. Request help for circuits that you couldn't find anywhere else, how a circuit works etc. Discuss anything related to electronic circuits.

Moderator: pebe

Post a reply

Problems with battery discharging circuit

Postby Harneet » Mon Sep 14, 2015 3:31 pm

I have a circuit that aims to discharge a battery and hence monitors it's voltage.
The circuit either drains 4 uA current through a 680k resistor or 20mA current which is driven by the DAC. The switching between these two scenarios is done using a 74hc125 ( have tried N FET as well)

The circuit diagram is attached.

Problem: When the switch corresponding to 680k is enabled it gets grounded but when switch corresponding to 10 ohm resistor is enabled it doesn't gets grounded.
I'm unable to spot the problem with the circuit .
Please help!!
Attachments
123.jpg
123.jpg (1.34 MiB) Viewed 7417 times
Harneet
 
Posts: 1
Joined: Mon Sep 14, 2015 3:21 pm
Top

Re: Problems with battery discharging circuit

Postby bwetman » Tue Oct 13, 2015 9:25 am

I think there is some problem with the hardware not with the software.
PCB Repair Tools - Rework Stencils, & SMT Stencils on Soldertools
bwetman
 
Posts: 15
Joined: Mon May 11, 2015 7:00 am
Location: Rolling Meadows, IL 60008
Top
Post a reply

Return to Electronic Circuits Help



Who is online

Users browsing this forum: No registered users and 3 guests



cron
Powered by phpBB® Forum Software © phpBB Group