It's been about 20 years since I did anything significant cct board manufacture, other than one or two components.
I have a small project where I will be interfacing 18 mains AC signals (220V) to a capacitor voltage drop cct to have an LED indicator for state of the mains (multi zone heating system)
Decided on cct components, have tested via Breadboard and all works fine ...
(not very complex ... it's this x 18 using common N rail )
Now in the past I have used Vero board and just drawn it out on graph paper, and then after a few attempts at layout on paper have created a board.
Obviously since my last creation PC's and software abound, is there any good free PC layout software for veroboard ? ... or is there a neater/better/simpler way to do this one off board.
It would seem uneconomic to create a pcb due to cost of etching materials.