•  
  •  

Coilless FM transmitter !

The RF oscillator using the inverter N2 and 10.7Mhz ceramic filter is driving the parallel combination of N4 to N6 through N3.Since these inverters are in parallel the output impedance will be low so that it can directly drive an aerial of 1/4th wavelength. Since the output of N4-N6 is square wave there will be a lot of harmonics in it. The 9th harmonics of 10.7Mhz (96.3Mhz) will hence be at the center of the FM band .
N1 is working as an audio amplifier. The audio signals from the microphone are amplified and fed to the varycap diode. The signal varies the capacitance of the varycap and hence varies the oscillator frequency which produce Frequency Modulation.

If there are any problems please contact webmaster@electronic-circuits-diagrams.com

Please share & like

Wattstopper PW-200-I PIR Wall Switch Occupancy Sensor, Dual Relay 120/277V IVORY
$34.99 Wattstopper PW-200-I PIR Wall Switch Occupancy Sensor, Dual Relay 120/277V IVORY picture
31-280P Pollak Ignition Switch for Universal
$32.53 31-280P Pollak Ignition Switch for Universal picture
100 Amp 120/240-Volt 24K -Watt Non-Fused General-Duty Double-Throw Safety Switch
$204.89 100 Amp 120/240-Volt 24K -Watt Non-Fused General-Duty Double-Throw Safety Switch picture
230/460V 5HP 3Ph Motor for JET Power tools SER 000579 W/ Actuator Switch 15A/5HP
$244.99 230/460V 5HP 3Ph Motor for JET Power tools SER 000579 W/ Actuator Switch 15A/5HP picture
10Pcs 12mm Vertical Slide Switch SPDT 1P2T With 3 Pins PCB Panel For Arduino Of
$5.69 10Pcs 12mm Vertical Slide Switch SPDT 1P2T With 3 Pins PCB Panel For Arduino Of picture