•  
  •  

Bass-treble tone control circuit

The LM1036 is a DC controlled tone (bass/treble), volume and balance circuit for stereo applications in car radio, TV and audio systems. An additional control input allows loudness compensation to be simply effected. Four control inputs provide control of the bass, treble, balance and volume functions through application of DC voltages from a remote control system or, alternatively, from four potentiometers which may be biased from a zener regulated supply provided on the circuit. Each tone response is defined by a single capacitor chosen to give the desired characteristic.

Features:

  • Wide supply voltage range, 9V to 16V
  • Large volume control range, 75 dB typical
  • Tone control, ±15 dB typical
  • Channel separation, 75 dB typical
  • Low distortion, 0.06% typical for an input level of 0.3 Vrms
  • High signal to noise, 80 dB typical for an input level of 0.3 Vrms
  • Few external components required

Note: Vcc can be anything between 9V to 16V and the output capacitors are 10uF/25V electrolytic.

If there are any problems please contact webmaster@electronic-circuits-diagrams.com

Please share & like

LM308AH Genuine NATIONAL Semiconductor OP-AMP U.S.A. (1 Piece) New Old Stock
$9.95 LM308AH Genuine NATIONAL Semiconductor OP-AMP U.S.A. (1 Piece) New Old Stock  picture
NIB Intercable Danmark SC3DA6010 3-Phase Semiconductor Contactor
$240.0 NIB Intercable Danmark SC3DA6010 3-Phase Semiconductor Contactor picture
National Semiconductor LM2901M Comparator Quad SMD IC OM0200C 5 pieces
$5.5 National Semiconductor LM2901M Comparator Quad SMD IC OM0200C 5 pieces picture
LM310H Genuine National Semiconductor Voltage Follower 8-pin Metal Can USA 1pc
$9.95 LM310H Genuine National Semiconductor Voltage Follower 8-pin Metal Can USA 1pc picture
LM311H Genuine National Semiconductor Comparator 8-Pin TO-99 U.S.A. 1 piece NOS
$8.89 LM311H Genuine National Semiconductor Comparator 8-Pin TO-99 U.S.A. 1 piece NOS picture
  • Abdul Basith

    can any one explain how the circuit works and what values of capacitor should we put on that chip to modify a bit if needed

    • admin

      Hi,
      Have you tried the datasheet? It contains a ton of information.